🔌 लेज़र स्रोत त्रुटि

Laser source error

❗Work in the diagnostic program should be entrusted to the equipment supplier's technical specialist or a private master❗

❗All errors related to the source going into error are solved by rebooting the source.

You can reboot the source 2 times, then it will go into software lock, requiring connection through diagnostic program and error removal.

Other source repair methods involve replacing its blocks:

1) Power supply for diodes often fails — for this reason, equipment must work with a voltage stabilizer;

2) Optical cable burnout or break is treated only by full fiber optic replacement (requires specialized service);

3) Chip or burnout of optical fiber quartz connector can be repaired by polishing the connector. ❗BE CAREFUL WITH CONNECTOR POLISHING SPECIALIST SELECTION❗;

4) When power fades, diode replacement is possible, but work cost may equal new source cost.

❗BEFORE REMOVING ERROR, CHECK LOG FILE WITH ERROR TYPE TO UNDERSTAND CRITICALITY❗

You can find the diagnostic program for your source type and power on manufacturer official sites by clicking the button below.