Fiber laser settings for 3 mm stainless steel at 3 kW
Updated:
A 3 kW fiber laser cuts 3 mm stainless steel with nitrogen at 12–16 bar and 7–10.5 m/min. For this combination we have three regimes: the base one from the source maker’s table and two alternatives from other sources.
Stainless steel cutting speed and gas pressure at 3 kW
Which regime to start with
- Base regime. The starting point for most 3 kW machines, from the source maker’s own table.
- Alternative 1. Gas pressure 4 bar higher. Source: MAX 3000W, Head: WSX. Try it when burr forms on the bottom edge.
- Alternative 2. Faster: 10.5 m/min against 7–10 m/min. Gas pressure 4 bar higher. Source: MAX MFSC-3000X-50um, Head: none. Try it when the cut is clean and you want more speed; if the edge gets worse, go back to the base regime.
Cutting time and gas consumption per metre
At these speeds one metre of cut takes about 6–9 seconds. Nitrogen flow through the nozzle is about 46.1–86.8 m³ per hour, or 77–164 litres per metre of cut, not counting piercing.
Stainless steel cutting speed chart: neighbouring thickness and power
| Thickness · power | Gas | Speed, m/min |
|---|---|---|
| 1 mm · 3 kW | N₂ | 28–35 |
| 2 mm · 3 kW | N₂ | 18–24 |
| 3 mm · 2 kW | N₂ / air | 5 |
| 3 mm · 3 kW | N₂ | 7–10 |
| 3 mm · 4 kW | N₂ | 10–12 |
| 3 mm · 6 kW | N₂ | 15–18 |
| 4 mm · 3 kW | N₂ | 5–6.5 |
| 5 mm · 3 kW | N₂ | 3–3.6 |
Going from 3 kW to 4 kW gives about 29% more speed on 3 mm with nitrogen.
Common stainless steel cutting defects with nitrogen




Not sure which one you have? Send a photo of the edge to the app and it names the defect and the fix.
Related questions
- What is the thickest stainless steel a 3 kW fiber laser cuts?
- Our tables go up to 16 mm stainless steel at 3 kW, at 0.3 m/min with nitrogen or air. The next thickness, 18 mm, starts from 6 kW.
- Why is the speed a range?
- Sheet surface, stainless steel grade, gas purity and pressure at the nozzle and the state of the protective window all shift the result. Start at the lower value, make a test cut and raise the speed in 5% steps while the bottom edge stays clean.
- Where are focus, cutting height and nozzle?
- They depend on the cutting head and lens, so a single number is often wrong for your machine. The app shows the full regime and fits it to the machine you add to your profile.