Fiber laser settings for 3 mm aluminium at 3 kW
Updated:
A 3 kW fiber laser cuts 3 mm aluminium with nitrogen at 11–16 bar and 5–9 m/min. For this combination we have four regimes: the base one from the source maker’s table and three alternatives from other sources.
Aluminium cutting speed and gas pressure at 3 kW
Which regime to start with
- Base regime. The starting point for most 3 kW machines, from the source maker’s own table.
- Alternative 1. Slower: 5 m/min against 7–8 m/min. Gas pressure 3 bar lower. Source: IPG, Head: none. Try it when the base regime does not cut through or leaves burr on the bottom edge.
- Alternative 2. Faster: 8 m/min against 7–8 m/min. Gas pressure 2 bar higher. Source: IPG 3000W, Head: Raytools 110. Try it when the cut is clean and you want more speed; if the edge gets worse, go back to the base regime.
- Alternative 3. Faster: 9 m/min against 7–8 m/min. Gas pressure 2 bar higher. Source: MAX MFSC-3000X-50um, Head: none. Try it when the cut is clean and you want more speed; if the edge gets worse, go back to the base regime.
Cutting time and gas consumption per metre
At these speeds one metre of cut takes about 7–12 seconds. Nitrogen flow through the nozzle is about 34–86.8 m³ per hour, or 71–161 litres per metre of cut, not counting piercing.
Aluminium cutting speed chart: neighbouring thickness and power
| Thickness · power | Gas | Speed, m/min |
|---|---|---|
| 1 mm · 3 kW | N₂ | 25–30 |
| 2 mm · 3 kW | N₂ | 15–18 |
| 3 mm · 2 kW | N₂ / air | 4 |
| 3 mm · 3 kW | N₂ | 7–8 |
| 3 mm · 4 kW | N₂ | 10–13 |
| 3 mm · 6 kW | N₂ | 14–16 |
| 4 mm · 3 kW | N₂ | 5–6 |
| 5 mm · 3 kW | N₂ | 2.5–3 |
Going from 3 kW to 4 kW gives about 53% more speed on 3 mm with nitrogen.
Common aluminium cutting defects with nitrogen



Not sure which one you have? Send a photo of the edge to the app and it names the defect and the fix.
Related questions
- What is the thickest aluminium a 3 kW fiber laser cuts?
- Our tables go up to 10 mm aluminium at 3 kW, at 0.4 m/min with nitrogen or air. The next thickness, 12 mm, starts from 4 kW.
- Why is the speed a range?
- Sheet surface, aluminium grade, gas purity and pressure at the nozzle and the state of the protective window all shift the result. Start at the lower value, make a test cut and raise the speed in 5% steps while the bottom edge stays clean.
- Where are focus, cutting height and nozzle?
- They depend on the cutting head and lens, so a single number is often wrong for your machine. The app shows the full regime and fits it to the machine you add to your profile.