Fiber laser settings for 2 mm brass at 3 kW
Updated:
Short answer
A 3 kW fiber laser cuts 2 mm brass with nitrogen at 12 bar and 10–15 m/min. For this combination we have one regime, from the source maker’s table.
Brass cutting speed and gas pressure at 3 kW
Base regime · Brass · 2 mm · 3 kW
RFL-3000(50u), Cutting head focal length: Collimating 100/Focal 150
Gas
N₂
Gas pressure
12bar
Speed
10–15m/min
Power
100%
Frequency
5000Hz
Duty cycle
100%
Focus
in the app
Cutting height
in the app
Nozzle
in the app
Cutting time and gas consumption per metre
At these speeds one metre of cut takes about 4–6 seconds. Nitrogen flow through the nozzle is about 29.5 m³ per hour, or 33–49 litres per metre of cut, not counting piercing.
Brass cutting speed chart: neighbouring thickness and power
| Thickness · power | Gas | Speed, m/min |
|---|---|---|
| 1 mm · 3 kW | N₂ | 20–28 |
| 2 mm · 2 kW | N₂ / air | 8 |
| 2 mm · 3 kW | N₂ | 10–15 |
| 2 mm · 4 kW | N₂ | 12–15 |
| 2 mm · 6 kW | N₂ | 18–20 |
| 3 mm · 3 kW | N₂ | 5–6 |
| 4 mm · 3 kW | N₂ | 2.5–3 |
Going from 3 kW to 4 kW gives about 8% more speed on 2 mm with nitrogen.
Common brass cutting defects with nitrogen


Not sure which one you have? Send a photo of the edge to the app and it names the defect and the fix.
Related questions
- What is the thickest brass a 3 kW fiber laser cuts?
- Our tables go up to 6 mm brass at 3 kW, at 0.8–1 m/min with nitrogen. The next thickness, 8 mm, starts from 4 kW.
- Why is the speed a range?
- Sheet surface, brass grade, gas purity and pressure at the nozzle and the state of the protective window all shift the result. Start at the lower value, make a test cut and raise the speed in 5% steps while the bottom edge stays clean.
- Where are focus, cutting height and nozzle?
- They depend on the cutting head and lens, so a single number is often wrong for your machine. The app shows the full regime and fits it to the machine you add to your profile.