Fiber laser settings for 3 mm stainless steel at 1 kW
Updated:
A 1 kW fiber laser cuts 3 mm stainless steel with nitrogen or air at 14–16 bar and 2.3–3 m/min. For this combination we have two regimes: the base one from the source maker’s table and one alternative from another source.
Stainless steel cutting speed and gas pressure at 1 kW
Which regime to start with
- Base regime. The starting point for most 1 kW machines, from the source maker’s own table.
- Alternative. Faster: 3 m/min against 2.3–2.5 m/min. Gas pressure 2 bar higher. Source: Raycus 1000W, Head: none. Try it when the cut is clean and you want more speed; if the edge gets worse, go back to the base regime.
Cutting time and gas consumption per metre
At these speeds one metre of cut takes about 20–26 seconds. Nitrogen or air flow through the nozzle is about 53.2–86.8 m³ per hour, or 354–482 litres per metre of cut, not counting piercing.
Stainless steel cutting speed chart: neighbouring thickness and power
| Thickness · power | Gas | Speed, m/min |
|---|---|---|
| 1 mm · 1 kW | N₂ / air | 21–23 |
| 2 mm · 1 kW | N₂ / air | 6.5–7 |
| 3 mm · 500 W | N₂ / air | 0.9–1.1 |
| 3 mm · 1 kW | N₂ / air | 2.3–2.5 |
| 3 mm · 1.5 kW | N₂ / air | 4.5 |
| 3 mm · 2 kW | N₂ / air | 5 |
| 4 mm · 1 kW | N₂ / air | 1.4–1.6 |
| 5 mm · 1 kW | N₂ / air | 0.6–0.7 |
Going from 1 kW to 1.5 kW gives about 88% more speed on 3 mm with nitrogen or air.
Common stainless steel cutting defects with nitrogen or air




Not sure which one you have? Send a photo of the edge to the app and it names the defect and the fix.
Related questions
- What is the thickest stainless steel a 1 kW fiber laser cuts?
- Our tables go up to 6 mm stainless steel at 1 kW, at 0.5–0.6 m/min with nitrogen or air. The next thickness, 8 mm, starts from 2 kW.
- Why is the speed a range?
- Sheet surface, stainless steel grade, gas purity and pressure at the nozzle and the state of the protective window all shift the result. Start at the lower value, make a test cut and raise the speed in 5% steps while the bottom edge stays clean.
- Where are focus, cutting height and nozzle?
- They depend on the cutting head and lens, so a single number is often wrong for your machine. The app shows the full regime and fits it to the machine you add to your profile.