Many cut quality problems are maintenance problems: a dirty protective window, a worn nozzle or a beam that drifted off centre. These answers give a maintenance routine by interval and show how to find misalignment with a burn-paper test instead of guessing from the cut.
A working routine covers four intervals: daily lens and nozzle checks, weekly rail and optics cleaning, monthly gas-line and filter inspection, and periodic chiller and beam-path service tracked by operating hours, not the calendar. Skipping the daily checks is what causes most of the defects covered elsewhere on this site.
Read the answer →Misalignment shows up as quality that differs by direction or position on the table, not as a single obvious fault: cuts fine on one axis but rough on the other, or good near the centre and worse toward the edges. A burn-paper test at two points on the beam path finds it faster than guessing from the cut alone.
Read the answer →SBM Laser Help carries cutting and piercing parameter tables by material, thickness and gas, photo diagnosis of cut defects, machine and chiller error codes, and gas consumption calculators. Free account, no card.