Gas choice decides edge colour, cutting speed and most of the running cost. These answers cover when to cut with oxygen and when with nitrogen, whether stainless can be cut with oxygen, how nozzle diameter changes gas flow, how much nitrogen a machine uses per hour at real pressures, and how long a nitrogen generator takes to pay back against cylinders or a tank.
All cutting modes by metal, thickness, gas and laser power, with alternative modes, are in the SBM Laser Help parameter tables.Parameter tables in the app →
Nozzle diameter follows thickness and gas: small single nozzles of 1.0–1.5 mm for oxygen cutting of mild steel, larger double nozzles of 1.4–3.0 mm for nitrogen cutting where a wide, high-pressure jet must clear the melt. Too large a nozzle wastes gas and softens the jet; too small starves the kerf.
Read the answer →Consumption is driven by nozzle diameter and pressure, not by the laser power: a 2.0 mm nozzle at 15 bar puts roughly 30–45 m³/h through the kerf, and a 3.0 mm nozzle at 20 bar can exceed 90 m³/h. That is why thick-plate nitrogen cutting is often the largest single line in the cost per part.
Read the answer →Oxygen burns as it cuts, so it is faster and cheaper on mild steel and reaches greater thickness, but leaves an oxidised edge. Nitrogen only blows the melt away, giving a clean, weldable, corrosion-resistant edge on stainless and aluminium at higher pressure, lower speed and much higher gas cost.
Read the answer →It depends on hours cut per week and cylinder price, not on machine power. A shop running stainless several shifts a day on cylinder nitrogen often recovers a mid-size generator in one to two years; a shop cutting nitrogen only occasionally rarely breaks even.
Read the answer →Yes, and it is faster and cheaper than nitrogen, but the edge oxidises: it turns dark or straw-coloured and loses corrosion resistance right at the cut. It suits thick plate, structural parts and anything that gets ground or painted afterward — not visible or weld-critical parts.
Read the answer →SBM Laser Help carries cutting and piercing parameter tables by material, thickness and gas, photo diagnosis of cut defects, machine and chiller error codes, and gas consumption calculators. Free account, no card.